AlpineSoft Support Forums

Forum List => Technical Support => Topic started by: James SW on January 13, 2009, 11:06:01 PM

Title: Setting USB input Gain
Post by: James SW on January 13, 2009, 11:06:01 PM
Hi Just downloaded vinylstudio & all going well with the exception of controlling the input gain on the USB(via the control panel) , I can adjust it to a level that stops clipping but the apply button is in-active, so when I then close the check levels window to start recording the level defaults back to 100%.Any ideas  on how I activate the apply button?
Many thanks
James
Title: Re: Setting USB input Gain
Post by: Paul Sanders (AlpineSoft) on January 14, 2009, 08:59:11 AM
Hi,

I'm sorry to be the bearer of bad tidings, but setting the level slider in the Control panel achieves absolutely nothing, sad to say.  The signal is still being clipped *inside* your USB device, even if you can't see it.  For more details, plese refer to this topic:

http://www.alpinesoft.co.uk/forum/index.php?topic=18

If you can attenuate the signal going into the USB device that is the best solution.  I personally record through the sound card built into the PC (I have a Sound Blaster Extigy 24).  These generally have a 'proper' level control.
Title: Re: Setting USB input Gain
Post by: James SW on January 14, 2009, 05:28:40 PM
oh well :-\ I haven't got the money for a new sound card so would i be better using the analogue input on my p.c.?
Title: Re: Setting USB input Gain
Post by: Paul Sanders (AlpineSoft) on January 14, 2009, 05:33:08 PM
Yes, I think you would.  Anything is better than clipping, really.  I actually recorded my own collection through the sound card built into my PC and it sounds fine.  Record something quiet and listen on headphones, see if there's any background noise from the components inside the PC.  That's the only likely problem.

I really am sorry.  This problem bites a lot of people.  What USB device have you got, as a matter of interest?
Title: Re: Setting USB input Gain
Post by: James SW on January 14, 2009, 11:26:37 PM
I have an ion turntable that has Line level outputs on it so i`ll give that a go.
Many Thanks for all your help
Title: Re: Setting USB input Gain
Post by: Paul Sanders (AlpineSoft) on January 14, 2009, 11:31:37 PM
No manual control on the back of the unit then?  It looks like they have removed that in the later models :(  Anything to save a dollar...